How do I assemble the Shower Caddy?

Updated 10 months ago by Pine Tar Connoisseur

Just follow these four simple steps:

1.) Line up the two side pieces along flat edges, slide the backboard with tabs facing down into each long notch and lightly push down.

2.) Next, slide one Bigfoot soap saver diagonally on the middle slat and lay flat with the ridges facing up. Rinse and repeat with the second Bigfoot on the bottom level.

3.) Place the back slat with notches facing up into the bottom and slide the front slat into the top grooves of the shower caddy.

4.) Finally, run the rope through the top holes and knot each end firmly. Hang up and enjoy a better shower with your favorite Squatch suds!

How did we do?

Powered by HelpDocs (opens in a new tab)